ODL 17069000R Przewodnik Instalacji Pobierz pdf (Strona 13)

Carpenter Pencil

Metal Shears

Safety Equipment

Safety Glasses

Extension Tubes

Gloves

TOOLS & PARTS

Be sure to measure and cut if necessary, before

removing adhesive strip and assembling the Extension

Tube. Wear gloves when working with sharp edges.

When trimming Extension Tubes, always measure and

start from the wide end where tube end diameter =

10” or 14”.

TIP

After referring to “Tube Length Chart” in Section 8,

use metal shears to shorten the Extension Tube. Allow

for a 1” overlap at each end where you will connect

each tube to another.

Once Extension Tubes are sized to the proper length,

remove tan backing paper from adhesive strip on

edge of Extension Tube. Beginning at one end of

the Extension Tube, over-lap the edges of the tube/s,

aligning the edge of the tube along the crimp on the

other side.

(Once contact is made with adhesive strip, parts

cannot be repositioned.)

Once contact is made with adhesive strip on an Extension

Tube, parts cannot be repositioned.

IMPORTANT

Adhesive Strip

Trimmed Extension Tube

Section-7

When Cutting Your Tube...

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 62 63

Brak uwag

ODL 17069000R Przewodnik Instalacji Strona 13